Up to 23 tools & Maximum Z travel!
If you want to get the most out of your PwnCNC ATC, these tool racks are a must on your custom table. If you have a QCW, check out our QCW racks.
First, they allow for the maximum number of tools due to their 55mm spacing. If you have an ATC, you want to be able to have it use as many tools as possible. You can fit up to 23 on a Foreman!
Second, these racks allow you to use the full 160mm of Z travel of your Z-20 slider on your Foreman. Shorter racks waste your Z travel with the tip of your tools below the wasteboard in the lowest position. Journeyman and Woodworker machines have 42mm less Z clearance.FAST SHIPPING * EASY INSTALLATION
The Foreman models provide enough clearance above the tool racks for tools up to 75mm below the holder.
You can also use the Foreman racks on the Woodworker and Journeyman if your machine is on the Riser Blocks, which bring the other machines up to the Foreman's Z clearance.
The racks support up to 1 1/8" flattening bits, and there's a special rack for our 3D Touch Probe on the Foreman.
They come in singles, double, triples, and quads. This minimizes the number of holes you need to put in your table to mount them. This maker file's bundle includes all of them.
They're also magnetically removable, which is very important for when you perform maintenance on your machine as fixed racks would block your access to the oil port on the Y axis in the typical mounting configuration.
This also allows you to temporarily remove the racks when you need to use the full width of the machine.
The magnets also allow them to "break away" in the event of a crash, possibly preventing damage, while at the same time, holding them firmly in place.
These are tall enough that most of your tools won't require holes be drilled in the table to support them. They've got over 2" of clearance between the holder and the table.
These racks are the perfect match for our Sidekick ATC dust boot. The combo is highly recommended.
They're also designed such that the mounting hardware doesn't show, making for the cleanest appearance possible. You can bolt them to the table, with M4 flat head screws and threaded inserts, but it double-sided tape works equally well.
You'll need 8x3mm magnets to press into the base and the holders.
Finally, they're slightly less wide than they are deep, preserving as much of your usable wasteboard as possible and supporting the Ugly Dog wasteboard setup.
These racks are feature-rich and affordable, especially if you purchase the quad racks.
